Default Password, Login and IP for your Comtrend CT+ router. User Manuals and How to Factory Reset your Comtrend CT+ router. To perform a Comtrend router Login or Reset, follow these instructions. Router The Comtrend CT+ router with 54mbps WiFi, 4 mbps ETH-ports. This manual provides information related to the installation, operation, and application support for immediate service by email at [email protected] com.
|Published (Last):||11 September 2011|
|PDF File Size:||6.88 Mb|
|ePub File Size:||5.49 Mb|
|Price:||Free* [*Free Regsitration Required]|
Wait for a few seconds until the test is finished, then the router will be ready to operate.
Easiest Way to Forward Ports on the Comtrend CT-536 Router
Comtrend default IP addresses Note that this still differs between Comtrend models and to be sure that you are trying to reach the correct ip check your specific model from the list below.
Intro Download Buy News Support. Comtrenr it, continue to print.
This is in contrast to static packet filtering which only examines a packet based on the information in the packet header. Table of Contents Add to my manuals Add.
All of the specified conditions in this classification rule must be satisfied for the rule to take effect. It can be changed by clicking the Change Policy button. Click the Finish button, when the screen displays as below. All of the specified conditions in this filter rule must be satisfied for the rule to take effect.
If the Network Authentication Shared mode checkbox is not shared that is, if open system authentication is usedno authentication is provided. MAC filtering policy and rules for the CT can be set according to the following procedure. The NAT submenu on the left side main panel will be displayed after reboot. Locate the file, and click the Open button. Page 32 STEP 3: Wireless bridge functionality will still be available and wireless stations will be able to associate to the AP.
Can take on any values from: Click the Add button to create a new connection. To add a dynamic DNS service, simply click the Add button. Configure precedence for the Queue entry. Select Enable Quality Of Service if required. Assign the entry to a specific network interface QoS enabled. WEP is a set of security services used to protect Make sure to activate the Internet Time server synchronization as described in 8.
COMTREND CORPORATION CT+ USER MANUAL Pdf Download.
Page comtrrnd Select a Service User should select the service from the list. We think that forwarding a port should be easy. Click the Add link. This process of opening a port is frequently called a port forwardsince you are forwarding a port from the internet to your home network.
Mac Encapsulation Routing mer 5. Which specific Comtrend model do you have? Our software does everything that you need to forward a port.
Comtrend Reset Instructions, Manuals and Default Settings | RouterReset
The DSL Settings dialog box allows you to select an appropriate modulation mode. Table of Contents Add to my manuals Add. The user can enable or disable event logging.
All other frames on this interface are dropped.
No part of this document may be translated, transcribed, reproduced, in any form, or by any means without prior written permission by Comtrend Corporation. If pressed down for more than 20 seconds, the CT will go into a firmware update state CFE boot mode. Got it, continue to print.
Custom Server User can enter the name of their manal. The default attributes are overridden when identical attributes with different values are configured. The results are displayed as follows. Don’t have an account? The cardboard box, the plastic contained in the packaging, and the parts that make up this router can be recycled in accordance with regionally established regulations.
The main menu has several options and selecting each of these options opens a submenu with more selections. This can be used to filter block or forward packets based on the originating device.
Enter the subnet mask for the LAN port. This information can be used to check the status of the device and its connections. Page 35 Enable LAN side firewall: The basic process to open a port is: